PG5904D Series - ATOP

4-Port RS232/485/422 and 2 x Fast-Ethernet or Gigabit RJ45, DNP3.0, Modbus, IEC 60870-5-101/103/104, IEC 61850 Smart Grid Protocol Gateway

• Dual 10/100 Mbps Ethernet port, with optional PoE PD or 100/1000 Mbps SFP Slot
• 4-port RS-232/422/485, baud rate up to 921.6 Kbps, D-Sub9 or Terminal Block, Optional 3kV Serial Isolation
• IP30 Metal housing with Aluminum heat sink
• Redundant DC power input, one Relay Output
• Strong EMC protection, works in environments from -40 to 85°C
• Same hardware platform for different protocol conversion (Modbus TCP/RTU/ASCII, DNP3.0 TCP or serial, IEC 60870-5-101, IEC 60870-5-103, IEC 60870-5-104, IEC 61850)
• Optional Full-License version for simultaneous transformation of multiple protocols
• User friendly configuration with a Java-Based Windows utility
• Embedded PPTP, IPsec VPN or OpenVPN for enhanced security

Product Description The PG59XX Series is a highly reliable and fault tolerant Industrial Protocol Gateway. Its powerful architecture provides seamless conversion between the different protocols Ethernet or Serial based. The serial devices communicating on different protocols could be integrated into the system and extend its reach over the gateway’s redundant Ethernet. This device is designed to work in most demanding industries such as power substations, power generation, oil and gas, farming and manufacturing. The configuration carried out through a use friendly, Java- Based Windows Utility called eNode Designer. It allows configuring target platforms, set device properties and protocol data point mapping. To do so, a project file representing the system should be created. This will include devices and the protocol applications running on them. The configuration is completely dependent on the “eNode Module” which represents that device or  application – but may include things such as changing the communication port settings and defining where data point information enters and leaves the eNode Designer system. PG59XX Series embeds an additional layer of security, allowing the devices to be deployed in topologies that request data to flow through the Internet and preventing sensitive control and monitoring data to be readable from malicious activities. IPsec VPN encryption, configurable in both peer-to-peer and peer-to-side modes will make sure the data passing is encrypted through a strong 128, 192 or 256-bit AES encryption. An additional highlight of ATOP protocol gateways is the ability to enable multiple protocols simultaneously. In contrast to conventional gateways, which require predefinition of a single master and slave protocol each, the Full-License model allows users to transform multiple incoming protocols in our protocol base to others compatible with the output side, achieving powerful protocol conversion functions, flexible operations, and easier maintenance. ApplicationThe protocol gateway’s embedded protocol stacks allow - Seamless conversion - Exception/error Management - Unsolicited event management for the protocols requiring them (such as DNP3) - High performance - Low cost The example shows how to Easily connect a Modbus Serial HMI, through ATOP’s Protocol Gateway to a IEC60870-5-101 Serial Slave RTU. The host HMI has the role of a Modbus Serial Master while the end-device to be accessed is a IEC60870-5-101 Serial Slave. ATOP’s protocol Gateway acts towards the HMI seamlessly as a Modbus Serial Slave, answering the poll commands or the write commands required by the Host by its virtual Modbus ID. Meanwhile, it acts as a IEC60870-5-101 Serial Master, with regard to the end-device whose 101 address is mapped to the virtual Modbus ID that the HMI is accessing. Be careful! – all gateway functions listed in the datasheet refer to the “Gateway” role, and not which “host” or “slave” the gateway is connected to. In this example, the SKU shown is “MBSS-01SM” (Modbus Serial Slave to IEC60870-5-101 Serial Master)